Im doing the custom 3" dp and exhaust, what gauge steel should i use? 14,16,18? what is ideal?

 

Got me the only thing I can say about 3" exhaust is what everyone all ready knows---except riceboys--- 3" exhaust should be used only with turbo application.

 

he's turbo

 

yes he is

 

heh heh assumptions

i'd think the thicker the better but then also heavier and change the tone

 

little higher than 14psi aint that right anthony... hehe o anthony make me one while your at it. note i have mine dualed out for the kit. ill give ya 200 for it. hehe let me know how that dp and exhaust thing works out.

 

yea just a little bit higher then 14 psi I think im gonna go for the 3" groupbuy, which sucks bc i dont have an exhaust anymore since i sold the tanabe! i hope i dont get pulled over while running an open dp, hehehe.

 

haha youre running around with an open DP? thats not too smart.

 

no i just gotta drive my car to my welder with an open dp, the only times ill do that is at the track though... i decided to buy 3" U bends and go with the custom exhaust and dp, parts were only $75 bucks through summit.

 

16 gauge is good