Finally tried a little video production. Don't laugh, its only my second one. This is ten minutes from 25 minutes of tape of his last run at EXPO8. Sorry about the loose camera vibration, but you can still hear that wonderful engine.

http://www.youtube.com/watch?v=3RyWdr4PybM

 

smooth driving

 

schweet , makes me want to move closer to VA

 

yeah that was some smooth driving, not incredibly fast but consistent, on the lines. car seems healthy, what mods?

 

That wasn't an e-brake i heard yanked after coming off track into the garage was it?

NO NO = brake pads melting to rotors and even the possibility of catching on fire.

Edit: watched again a couple times, may have just been that mount rattling

 

Expo vids never get old. I'm sure I wasn't the only one acting like I was shifting and holding my line while watching the vid. Thanks for sharing.

 

He is smooth. I probably cut out his best laps and to be honest I didn't even think about that when editing the footage. His mods (hope he doesn't mind me sharing the info) as I remember are: Koni/CG Coil overs, Skunk 2 Camber Kit, J's CAI, BC Spec III cams and gear set, ATS 4.9 FD, Comtech Flywheel and ACT XTSS clutch, Gator Axles, Type One header/2.5" SS pipes/Spoon N1 muffler, Hondata ECU tuned by AR Fabrication in Winchester VA, Cobalt track pads, 4 point roll bar, Sparco seats and G Force harnesses....... yup, thats about it.

 

No e-brake pulled.

 

Sweet vid! Real smooth driving Camera rattle really wasn't bad

 

Good video pops. We've definitely got to fix that rattle on the camera. These were my first three laps of the session so I was just getting the car warmed up and up to speed. Don't mind that bobble on the last lap at OakTree either. Hope you guys enjoy it, this stuff always gets me excited for the next event.