i have searched but didnt find.. how much is one marking on the gears in real degrees?

thnx

-Fredrik

 

they go in 1 degree increments

 

This is obvious. He's asking if its 1 camshaft degree or 1 crankshaft degree.

 

it is neither 1 crank degree or one 1 degree. They are simply marked......

 

With the couple of sets I've used one mark was 4 crank degrees or 2 cam degrees.

 

but the markings are diffrent on exhaust and intake? should it be that way?

 

the should be facing each other on TDC

 

No buddy at buddy crub knows?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Master of the Universe &raquo;</TD></TR><TR><TD CLASS="quote">No buddy at buddy crub knows?

</TD></TR></TABLE>

When I spoke with buddy club about this exact matter they told me, "to properly install camshafts they need to be degreed to the crank, the notches on the gears are for reference only"

While this is correct it is a shitty answer.

 

Translation, da markings are not functional and use of them will render you SOL (shiatt out of luck).