hello i am new here i am a experienced honda technitian and i am building a 92 integra ls turbo my setup is stock block and head (milled both) and i want to put wiseco pistons eagle rods and performance rings all new gasket and seals and im going to run a 57 trim turbo setup on it if i go overbore +.5 mm on stock sleeves will my engine hold up i have never tried this before and any advice is appreciated thanks

 

You can safely overbore the stock sleeves to 81.5mm. The majority of stock sleeve builds are going to be at that diameter.

 

thanks for the info much appreciated it will giv a good bang or the pistons will change holes i am hoping for the best