FS: Fujitsubo SuperEX Header B-Series >> Stainless JDM FGK Jasma
Thread Starter
Honda-Tech Member
Joined: Oct 2001
Posts: 7,536
Likes: 1
From: Edgewater, MD / La Jolla, CA
FS: Fujitsubo SuperEX Header SOLD
*** SOLD ***
Fujitsubo - the name needs no introduction! Among Japan's best Exhaust companies.
This header arrived in beautifully polished condition (polishing includes the inner welds, which the company cleans up on all of the tubes inside), and like a fine wine that gets better with age, has gained a nice blue'ish and rust tint to it. The welds are all
and it's just a stunning exhaust manifold (if that's possible!). Seriously, forget Harry Winston and pop your hood to show her this...
Anyway, the header does have some dimpling on the bottom, and the middle gasket needs to be replaced (I'm including two sheets of new exhaust gasket material, and the original gasket, which you can trace and then cut into the sheets). The flanges are all good, and it includes a JDM 2.5" donut gasket.
New from a place like PasswordJDM, these are $689.99 + shipping (which runs about $75 to the East Coast).
For you, the JDM connoisseur, $300 local pickup, $335 shipped.
(this picture came out weird - the only place there is scraping on the tubing is the bottom)
Modified by Tweakmeister at 3:10 PM 4/6/2008
Modified by Tweakmeister at 7:47 PM 4/12/2008
Modified by Tweakmeister at 10:29 PM 4/30/2008
Fujitsubo - the name needs no introduction! Among Japan's best Exhaust companies.
This header arrived in beautifully polished condition (polishing includes the inner welds, which the company cleans up on all of the tubes inside), and like a fine wine that gets better with age, has gained a nice blue'ish and rust tint to it. The welds are all
and it's just a stunning exhaust manifold (if that's possible!). Seriously, forget Harry Winston and pop your hood to show her this...Anyway, the header does have some dimpling on the bottom, and the middle gasket needs to be replaced (I'm including two sheets of new exhaust gasket material, and the original gasket, which you can trace and then cut into the sheets). The flanges are all good, and it includes a JDM 2.5" donut gasket.
New from a place like PasswordJDM, these are $689.99 + shipping (which runs about $75 to the East Coast).
For you, the JDM connoisseur, $300 local pickup, $335 shipped.
(this picture came out weird - the only place there is scraping on the tubing is the bottom)
Modified by Tweakmeister at 3:10 PM 4/6/2008
Modified by Tweakmeister at 7:47 PM 4/12/2008
Modified by Tweakmeister at 10:29 PM 4/30/2008
up for this man! good header!
Thread
Thread Starter
Forum
Replies
Last Post
Tweakmeister
Mid-Atlantic (Sales)
1
Apr 12, 2008 03:48 PM
gtowni3
Honda Civic / Del Sol (1992 - 2000)
29
May 12, 2005 03:14 PM
kabob
Acura Integra Type-R
9
Mar 4, 2003 02:16 PM
