Acura B18C1 "Bare" Race Block
Thread Starter
Honda-Tech Member
Joined: Sep 2004
Posts: 32
Likes: 0
From: Fl, USA
f/s Acura B18C1 "Bare" Race Block
This is a B18C1 block... I was preparing this block for some major boost and never got around to finishing it. The block has a fresh hone on it from J&J Balancing. It is Standared bore at 81mm. I have a set of stock pistons, rods and cranks set in there for the time being (they go with the block). the block was filled with Moroso Engine Filler which Helps prevent thin cylinder walls from cracking and improves ring seal by keeping cylinders round Also dampens unwanted vibrations Has expansion rate very similar to aluminum. It Also comes with a block gaurd that is new. The block is missing the sensors, oil pump, oil pan, and waterpump.
ASKING $400 OBO
If intrested contact Ruben by-
Email- Rlvazquez@comcast.net
Phone- 561-315-6767
Modified by Vtec5500 at 10:46 AM 4/2/2008
ASKING $400 OBO
If intrested contact Ruben by-
Email- Rlvazquez@comcast.net
Phone- 561-315-6767
Modified by Vtec5500 at 10:46 AM 4/2/2008
Joined: Sep 2006
Posts: 21
Likes: 0
From: Santa Ana, Ca, US
Re: f/s Acura B18C1 "Bare" Race Block (Vtec5500)
Thread
Thread Starter
Forum
Replies
Last Post
360infinite-usa
Forced Induction
673
Jun 26, 2012 12:42 PM
