I read a thread in this section that talked about mounting and making holes for an ITR wing..however it was a thread for a GSR and was obviously full of the "take old off, replace with new" responses.

My question is this, I'm driving a 94 Integra LS 3-dr and it's got what looks like two knockouts on each side of the hatch for holes to be drilled.

Are these what I want to drill through in order to access mounting holes on the wing or is there somewhere else the holes need to be made? They look about like where it'd need to be mounted.

 

if its factory wing then yes. if its ebay i would double check to make sure.

 

Fortunately it's factory.

I'll give mounting it myself a try before calling Acura..shouldn't need any info if I pull a few measurements myself.

I appreciate it dude.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by cherryhatch00 &raquo;</TD></TR><TR><TD CLASS="quote">Fortunately it's factory.

I'll give mounting it myself a try before calling Acura..shouldn't need any info if I pull a few measurements myself.

I appreciate it dude.</TD></TR></TABLE>

i doubt acura will know ****. i hate dealerships they are the highest paid most unknowledgable people there are...

if its factory make sure you get the gaskets for that wing...