K24 Bottom End Race Parts
Thread Starter
Member
Joined: Apr 2002
Posts: 1,095
Likes: 0
From: Snailville, TX, USA
K24 Bottom End Race Parts
Decided to go a bit more all out race with a motor:
Selling rods, pistons and bearings from the K24 bottom end built.
88mm CP X-Forged pistons, w/rings 12.5:1
IB-spec k24 H-beam rods (BluePrint Mfg)
ACL Standard Bearings (rods)
These have all been staged in the motor, but nothing more than turned over by hand. Then decided he wanted a LOT MORE compression and a bit more bore.
The pistons were +$100 for the X-forged over the normal cost of CP's
I would take $750.00 for it all. Ready to drop into an 88mm block!
Ready for pickup in SE Houston, still in the motor and lubricated.
PM or email me at ricky@silverbeast.com
Selling rods, pistons and bearings from the K24 bottom end built.
88mm CP X-Forged pistons, w/rings 12.5:1
IB-spec k24 H-beam rods (BluePrint Mfg)
ACL Standard Bearings (rods)
These have all been staged in the motor, but nothing more than turned over by hand. Then decided he wanted a LOT MORE compression and a bit more bore.
The pistons were +$100 for the X-forged over the normal cost of CP's
I would take $750.00 for it all. Ready to drop into an 88mm block!
Ready for pickup in SE Houston, still in the motor and lubricated.
PM or email me at ricky@silverbeast.com
Thread
Thread Starter
Forum
Replies
Last Post
