just swapped a jdm b16a sir2 motor in my 95 civic dx, i added knock sensor, and vtec wires, i was told jdm motors with the jdm computer didnt need vtec oil wires added, it starts and idles funny, and when i push on the gas it dies....any ideas, i need to figure this out quick...........i dont know for sure if the knock wire is in the computer very well, it is throwin a cel

 

cel was i guess code 21 vtec solenoid
it did it wierd
long, long short
long, short
long, long, short,
long, long, short
long, short
long, long, short
those being the blinking cel lights for the codes, it does 21, 21, 11, 21, 21, 11
doesnt make sense to me
but that would cause it to idle bad and die when i press the gas would it?

 

bump for help

 

oh, the srs was blinking when i ran a jumper wire, not the cel, is that normal?

 

bump

 

chek that you coneected the wires correctly at the ecu side!