just did swap, it dies, need fast help
#1
Honda-Tech Member
Thread Starter
just did swap, it dies, need fast help
just swapped a jdm b16a sir2 motor in my 95 civic dx, i added knock sensor, and vtec wires, i was told jdm motors with the jdm computer didnt need vtec oil wires added, it starts and idles funny, and when i push on the gas it dies....any ideas, i need to figure this out quick...........i dont know for sure if the knock wire is in the computer very well, it is throwin a cel
#2
Honda-Tech Member
Thread Starter
Re: just did swap, it dies, need fast help (cehcivic15)
cel was i guess code 21 vtec solenoid
it did it wierd
long, long short
long, short
long, long, short,
long, long, short
long, short
long, long, short
those being the blinking cel lights for the codes, it does 21, 21, 11, 21, 21, 11
doesnt make sense to me
but that would cause it to idle bad and die when i press the gas would it?
it did it wierd
long, long short
long, short
long, long, short,
long, long, short
long, short
long, long, short
those being the blinking cel lights for the codes, it does 21, 21, 11, 21, 21, 11
doesnt make sense to me
but that would cause it to idle bad and die when i press the gas would it?
Thread
Thread Starter
Forum
Replies
Last Post
Exxel82
Honda Civic / Del Sol (1992 - 2000)
3
05-01-2007 08:15 AM
civickidd99
Honda Civic / Del Sol (1992 - 2000)
9
09-21-2003 01:36 PM
leprechan117
Honda Civic / Del Sol (1992 - 2000)
4
05-10-2003 08:51 PM