i just got my hands on a 1994 integra, i am going to build the non v-tech motor for boost. I would like to run around 15 pounds .. i was curious to know what kind of cams to put in it. and i was thinken about using eagle rods and wiseco pistons with arp head bolts but im not sure if thats a good and strong way to go .. and i also dont know what kind of head gasket to use .. any suggestions?

 

research noober...

 

Take a little trip to the F.I. section and you will figure out what you need

 

why 15psi, why not 55psi? read in the FI section so you know what your getting yourself into.

 

lol GET YOUR FLAME SUIT ON!!!!!! its Vtec btw.

 

eagle rods
pistons of your choice
stock headgasket
stock cams
adequate fuel system
good tune

simple huh?


Modified by doood at 8:06 AM 9/1/2007

 

First part of a strong build is READING!!

 

hope you got yours on... it's "VTEC". not Vtec, not v-tech, not vtak- not Vetch, not anything other than "VTEC"

 

look up this book on amazon.com

maximum boost by corky bell.

read that first and then go from there.....the fuel system is as expensive as the turbo setup itself.....

 

non-VTEC FTW! get forced induction cams from brian crower. http://www.briancrower.com