what are your thoughts on a JUN stage 2 head package.... the only thing i dont get are vavles... but for aroun 2000 i get all except valves... im putting a ITR head on a built LS block... anyone know where else except for diabloautosports.com i can get the package.. i tried searchin and found lots of sites but non have the JUN head package..

thanx

 

http://www.inlinefour.com

Why are you paying so much? I am running the cams, valvesprings, retainers, camgears, and JUN ported and polished head, and it did not cost that much

 

what is included in a JUN 3 head package? how much do they usually go for total?

 

Are you refering to the stage 2 cam kit?
Can you please define built on your LS motor?


Jason

 

call me at 407 977 9sec
titan motorsports
jun stage 3 and retainers and springs for less than $1600
shipped
have them in stock

 

What kind of retainer and springs JUN?

 

my built LS has 11.5 JE pistons and my block is bored to 84mm..sleeved...eagle rods... (its actually being built now) the JUN 3.. will that be harsh on my car like idle and stuff... should i just go for stage 3 instead of 2

thanx

 

hey canuck.. did u buy your parts seperatly.. or as a complete set.

where is a good place (near NC or around east coast) that i can send my head to be P & P and get it back within a week or two

thanx

 

Harsh for idle? Should not be a problem with idle, if you are running the proper engine management.
As for a PnP job that is close to home, ask Lip, Mike@ IPS or Greg (Vtec4gs). I think they, have at one time, used someone on the east coast. I, personally, have not had my head done yet... yet...
Who is doing the build?


Jason

 

dont worry about the JUN idle, it will idle like stock. i have em, so i definitely know. now TODA cams idle a little rougher. i got my JUN 3 cams, gears, retainers, valve springs and ultra lightweight flywheel for 2200. make sure u have all JUN components. dont b cheap and mix and match crower w/ JUN or any other brands.