i was drilling a hole under were the clutch goes through the firewall for my amp wire....and i drilled it fine with no problems....now tonight i drilled a hole right under it...and the drill drilled through a thin piece of sheet metel...and then i guess started to drill threw the actual firewall?.....and then all of a sudden the bit started twisting wires around it...i quick pulled the drill out and it cut two wires and they came out on the bit......it was the wire for the right turn signal.....anyone know how i get to these wires??

 

way to go is that ur first amp that u tried to put on u should have look theres a place to run a amp wire in every car good luck

 

why would u drill a hole when u couldve just put it thru the grommet. also u can just repair the wire solder and heat shrink and some wire. thats all u need