Could someone point me to a link on how to fit together all those pipes for a DRAG kit for the Integra? or, just describe it.....Thanks

Ethan

 

a small 2" diameter 90deg angle goes to the compressor outlet
a staright the 90 deg then another 90 deg, about 2" in diamter goes from the above pipe to the IC inlet ( the 2" inlet)
the U bend, goes from outlet of IC then the 90 deg rubber boost, then the charge pipe

before IC should be 2", after IC is 2.25"

 

Its like a puzzle for horsepower. Once you start actually doing it it goes pretty easy. If you're just trying to put it together off the car you might have some trouble.

 

k, so what's this 45 degree bend for?

 

for the air filter...
it should go like this, compressor outlet, the 45 deg with DRAG stamp on it, then then funky looking piping..they should all be 3" in diameter or 2.75"