I have searched and need more specific answers.

I currently have a 1994 Civic DX/CX nuckle/hub on my car. I want to put 95 Civic Si rotors and ABS calipers on these hubs. Given the fact that I buy the proper rotors, calipers and brackets will it bolt to this hub?

I am aware of the brake swap thread, but need this information to make my car Honda Challenge rules compliant.

 

https://honda-tech.com/zerothread?id=1484555

 

I am aware of the thread that is posted...I did notice that it referenced ITR calipers and it seem like the write up was done on an ek.

I just need a yes or no answer if 92-95 dx/cx/vx knuckles can accept 92-95 Ex/ Si 10.3" rotors and 92-95 Ex/Si ABS calipers and brackets without the milling mentioned in Blueintegraboys thread?

I need to stay with civic knuckles to avoid the taller integra ones for camber reasons.

Please let me know.

 

The knuckles referenced in the thread are the same as your knuckles right now. There's no way of mounting larger calipers to a DX knuckle without the milling.

 

the 92-95 EX/Si calipers cannot go on a DX/CX knuckle/hub because they do not clear the 10.3" EX/Si rotors. The DX knuckles are different. The only larger calipers onto a DX knuckle are the ITR calipers with the milled brackets and grinded pads.

If you are looking for this setup, that was my old post, let me know I can machine the parts for ya.