I can't access anything from the bottom because of ATTS. So...any particular suggestions?

 

If you have the tools to remove the intake mani, why cant you go ahead and remove the atts as well?

 

Because it's a lot of work.

 

I couldnt get the IM off on my SH with the ATTS on . Its a PITA goodluck

 

even according the helms, you pull the atts.

 

I think I have read about it being done with out removing the atts on this site, either way it will be a bitch.

 

I was just looking at the engine bay. There's quite a bit of space behind the plenum, so can't I just a use an extension or two to get those lower nuts? The only problem I foresee with that is getting them back on, but it's not something a little creativity can't fix.

 

^