How do my bearings look? I started to hear a some knocking on my motor so i pulled the motor out and starting to inspect it. what do you guys think? Is it the curlpit?

 

look good to me, i had the same problem as you, it turn out to be one of my piston ring land crack

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by eg:R &raquo;</TD></TR><TR><TD CLASS="quote">look good to me, i had the same problem as you, it turn out to be one of my piston ring land crack</TD></TR></TABLE> yea if everyone agrees that the bearings are still good then it looks like the pistons are going to come out.

 

can I reuse old bearings if they are in good shape(74000KM)?

 

looks pretty typical from what i have seen. I would probably replace the really scratched up one, but i bet it would still run fine for a long time like that.

 

those look fine....it might just be piston slap

 

yea those look pretty ok, once u start seeing a gold finish under the silver coating, thats when u know you have problems, but those seem to be ok

 

They look to be in ok condition from what i've seen in the past.. What's up w/ dem finger nails though... LOL j/P

 

Looks good

 

Did you check the Main bearings. Was the noise always there after the enigne was built or did it just start, or is the block stock? Those rod bearing look really good.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by RICE POLICE SIP &raquo;</TD></TR><TR><TD CLASS="quote">They look to be in ok condition from what i've seen in the past.. What's up w/ dem finger nails though... LOL j/P </TD></TR></TABLE>

nasty....

you MUST be single... cause no female would put up with that ****...

 

Bearings look great but your nails are busted...J/K hahaha!!!...sorry just jumping on the bandwagon.

 

CUT YOUR FINGER NAILS...DAM

as for the bearings id replace and have your crank and rods checked anyways

 

bearings are fine but omg bet those things are hard to clean out