I found a deal on some WORKS and i was just wondering if anyone is running the same setup. o i think the backspacing is 42

 

check here
https://honda-tech.com/zerosearch

I found 277 results for spoon calipers

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by oldschoolflava &raquo;</TD></TR><TR><TD CLASS="quote">I found a deal on some WORKS and i was just wondering if anyone is running the same setup. o i think the backspacing is 42</TD></TR></TABLE>

yes they do on some rims, im running on 15"by7" ats complites, lots of clearance with the spooons!

 

I have 15" sw388 with the spoon calipers and had to run a 5mm spacers. It's all in the wheel sizing.

 

haha i wanna know too..since im trying to sell my rsz-r's to my friend..
depends on offset....right??

 

yes, but it depends of offset and spoke design.....

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Black R &raquo;</TD></TR><TR><TD CLASS="quote">yes, but it depends of offset and spoke design..... </TD></TR></TABLE>

How about those new 15x8 Rotas?
Looks like I'll need to get the rear lips rolled.

 

Mazda rims with a 5/8mm spacer work


spoonies are black so they are a little hard to see.

 

+35 K1's also work

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by jaa1311 &raquo;</TD></TR><TR><TD CLASS="quote">+35 K1's also work </TD></TR></TABLE>


ahh..... if only those came in 15x8.....

 

welcome to a LONG time ago:

https://honda-tech.com/zerothread?id=324343&page=1