I decided to go the boosted route once again in my SI... so there for i am either selling or parting out my all motor setup... The setup consists of...

81.5 MM LS Block/Crank
Weisco 12.1 CPR
Eagle Rods
ACL Race Bearings
ARP Headstuds
Cometic HG

b16b Head
3 angle valve job
flat dish race valves
full PNP job
dual springs/titanium retainers
Exospeed Custom Cams
Skunk2 port matched im and 70mm bbk tb
h22 injectors
AEM fpr
Skunk2 Camgears
(head was custom done at Exospeed 2600$ worth of labor not including valves or cams)

00 ITR Trans
Quaife LSD
3puck exedy clutch
7 lbs alum. CC Flywheel

build comes with the ANR Race header, and a cold air intake that the motor was tuned with..

Also a p28 chiped and tuned on CROME by howard at RLZ

this motor made 192 whp on pump gas with no timing at all... i am also willing to party the motor and trans, if i have enough people interetsed in parts...

i will take 6100$ for the complete motor trans ecu and axles... motor has 0 miles... since i just replaced the pistons, bearings and rings... if anyone wants parts of the motor i wont just sell the cams or the im or **** like that so dont ask... will part the trans and the motor so shoot me good offers... SI ran a 8.6 @ 90 on street tires at pageland, with a slipping clutch... this motor in a lighter car is def easy 12s, and its nitrous ready...
[IMG]I decided to go the boosted route once again in my SI... so there for i am either selling or parting out my all motor setup... The setup consists of...

81.5 MM LS Block/Crank
Weisco 12.1 CPR
Eagle Rods
ACL Race Bearings
ARP Headstuds
Cometic HG

b16b Head
3 angle valve job
flat dish race valves
full PNP job
dual springs/titanium retainers
Exospeed Custom Cams
Skunk2 port matched im and 70mm bbk tb
h22 injectors
AEM fpr
Skunk2 Camgears
(head was custom done at Exospeed 2600$ worth of labor not including valves or cams)

00 ITR Trans
Quaife LSD
3puck exedy clutch
7 lbs alum. CC Flywheel

build comes with the ANR Race header, and a cold air intake that the motor was tuned with..

Also a p28 chiped and tuned on CROME by howard at RLZ

this motor made 192 whp on pump gas with no timing at all... i am also willing to part the motor and trans, if i have enough people interetsed in parts...

i will take 6100$ for the complete motor trans ecu and axles... motor has 0 miles... since i just replaced the pistons, bearings and rings... if anyone wants parts of the motor i wont just sell the cams or the im or **** like that so dont ask... will part the trans and the motor so shoot me good offers... SI ran a 8.6 @ 90 on street tires at pageland, with a slipping clutch... this motor in a lighter car is def easy 12s, and its nitrous ready...

 

ttt

 

are u parting the headers?

 

make4 an offer

 

PMed

 

im tryin to sell my anr header. sick header

 

ttt

 

tttttt