We have finally aquired a dynojet here in my small caribbean island called Antigua.
It just went into full operation about a week ago, but the operator is a little bit green in the area, so I am wondering if his instructions are correct. I have a JDM ITR, so he told me to rev slowly in first to half my redline which 4000rpm, then shift to secound and do the same, then shift to third and flat foot the throttle until close to redline, then shift hard to fourth until redline. My question is, does this procedure seem right or am I only suppose to go until redline third?

 

no need to slam gears, just pick a gear (closest to a 1:1 gear ratio is best for accuracy) and floor it thru your desired rpm range once getting to your chosen gear