PoorMans Type R question- Skunk2 Stage2's good header ?
Guest
Posts: n/a
PoorMans Type R question- Skunk2 Stage2's good header ?
hey guys i am in the process of putting together a little motor for a daily driver and weekend track car- Here is my setup so far
GSR bottom end STOCK
B16 head
ARP headstuds
I have a set of skunk 2 stage 2's and a set of GSR cams- Am i better off putting in the GSR's because the skunks arent going to have enough compression? Is there any head gaskets that could bump me up to what i need compresion wise safely?
I also plan to run a 100 shot or so of wet nitrous at the track. How well would these respond to the skunks? and lastly anyone recomend a better header then my DC
Im thinking about a RAGE from what i searched it seemed pretty good.
GSR bottom end STOCK
B16 head
ARP headstuds
I have a set of skunk 2 stage 2's and a set of GSR cams- Am i better off putting in the GSR's because the skunks arent going to have enough compression? Is there any head gaskets that could bump me up to what i need compresion wise safely?
I also plan to run a 100 shot or so of wet nitrous at the track. How well would these respond to the skunks? and lastly anyone recomend a better header then my DC
Im thinking about a RAGE from what i searched it seemed pretty good.
Thread
Thread Starter
Forum
Replies
Last Post
LSD_Rob
All Motor / Naturally Aspirated
2
Mar 30, 2012 06:31 AM
vestalfootball72
Forced Induction
7
Oct 25, 2006 09:39 AM
