I've been running the inline manifold manifold on my motor with a stock b16 IM.

I am now building another b16 and am planning to rev it out to 10k (thats where the rev limit will be).

I guess the question is 1) Do I run a similar manifold with larger plenum? like AEBS or Skunk2 with similar runners?

2) Do I run a manifold like the GE or Victor X??

This is going on a B16 81.5mm bore. Is there a manifold that will leave some low end and breathe well into 10k?

I looked at a BBK that seemes to have a smaller plenum than the victor X but also the short runners.

Give me your input, I was thinking Victor X.

 

victor-x. i had the AEBS, it works good, but the X is better

 

Bump, please give setup!