How far will I need to mill head?
Thread Starter
Member
Joined: May 2001
Posts: 3,094
Likes: 0
From: The Pacific, Northwest
How far will I need to mill head?
I would like to acheive 10.1:1 CR with my stock Pr4(b18b) pistons, B16 head, Cometic .025 head gasket. As is, without any milling, its right over 9.6:1, how much would the head have to be milled to acheive 10.1:1?
Or, is there another head gasket out there that will get it done? I'v heard of 1 layer head gaskets, but have never seen them offered anywhere.
[Modified by BLK94RS, 11:44 AM 5/1/2002]
Or, is there another head gasket out there that will get it done? I'v heard of 1 layer head gaskets, but have never seen them offered anywhere.
[Modified by BLK94RS, 11:44 AM 5/1/2002]
Thread
Thread Starter
Forum
Replies
Last Post
blwnb16a
All Motor / Naturally Aspirated
7
Dec 18, 2003 02:59 PM
