How far will I need to mill head?
#1
Member
Thread Starter
Join Date: May 2001
Location: The Pacific, Northwest
Posts: 3,094
Likes: 0
Received 0 Likes
on
0 Posts
How far will I need to mill head?
I would like to acheive 10.1:1 CR with my stock Pr4(b18b) pistons, B16 head, Cometic .025 head gasket. As is, without any milling, its right over 9.6:1, how much would the head have to be milled to acheive 10.1:1?
Or, is there another head gasket out there that will get it done? I'v heard of 1 layer head gaskets, but have never seen them offered anywhere.
[Modified by BLK94RS, 11:44 AM 5/1/2002]
Or, is there another head gasket out there that will get it done? I'v heard of 1 layer head gaskets, but have never seen them offered anywhere.
[Modified by BLK94RS, 11:44 AM 5/1/2002]
Thread
Thread Starter
Forum
Replies
Last Post
blwnb16a
All Motor / Naturally Aspirated
7
12-18-2003 02:59 PM