Building Bottom end for turbo
Thread Starter
Honda-Tech Member
Joined: Jun 2006
Posts: 113
Likes: 0
From: upland, ca, usa
Building Bottom end for turbo
K so i want to build my b18b block and i was wondering what kind of pistons, sleeves, and rods i should get. It has a t3/t4 on there and i am ready to go all out. Oh and if i need anything other then that let me know as well.
I know i need the rings and crank as well
I know i need the rings and crank as well
Junior Member
Joined: Mar 2006
Posts: 681
Likes: 0
From: Deleware County, PA
The crank should be fine, ussually the last thing replaced.
Maybe go with some lower compression pistons (like 9:1), darton sleeves, eagle rods, oem bearings.
This all depends on your goals though. Personally I am building a block for about 300whp and I'm not getting it sleeved.
Maybe go with some lower compression pistons (like 9:1), darton sleeves, eagle rods, oem bearings.
This all depends on your goals though. Personally I am building a block for about 300whp and I'm not getting it sleeved.
Thread
Thread Starter
Forum
Replies
Last Post
JDM turbo DC
Forced Induction
7
Nov 9, 2005 12:55 PM
NeXtLeVeL_TyPe_R
Forced Induction
4
Sep 30, 2002 04:46 PM