Bseries Turbo Kit, very slightly used, $2500- New York
Thread Starter
Honda-Tech Member
Joined: Jan 2003
Posts: 7,987
Likes: 4
From: UPSTATE 518
Bseries Turbo Kit, very slightly used, $2500- New York
<U>MAKE OFFER NO REASONABLE OFFER REFUSED</U>
ALL ITEMS have less than 1k miles on thme and were purchased BRAND NEW
I WILL Part the kit out!!!!!!!!!!
-Garrett GT32 .50 cold/.78 hot W/custom internal wastegate at 8psi (purchased brand new was $750. $630shipped includes special oil feed flange and CUSTOM MADE 7.5psi internal wastegate (original wastegate was 22psi)
90 silicon elbow off turbo ($40 new) $25shipped or +$20 if u buy it with the turbo
-LSD motorsports log mani - $200shipped
-Precision 440 injectors (no resistor box needed!) 200shipped
-HKS "style" ssqv BOV- PENDING
- Joe P. Manual Boost controller "new style"- 35 shipped
-Stealthmode oil line kit, all necessary fittings/clamp/bolts (block fitting, feed line, turbo fittings, return line, oil pan flange NOT included)- PENDING
-tapped and welded oil pan- PENDING
-Johnny race car 6" intercool with extra mounting tabs- $170 shipped extra mounting tabs included
-Defi D-Gauge Boost gauge (lights up red, has been discontinued, hard to find)- PENDING
plenty of 2.5" high quality silicon couplers and tbolt clamps- make offer
-vacuum lines and t-fittings
- i will include 3 OBDI chips with crome pro tuned by xenocron for this setup. this should not be long term but it should run your car quite well until you can get your own tune- make offer
I will include the 2.5" mandrel bent intercooler piping which is for a 1st gen crx. they MAY fit a 2g but i doubt it will be direct (some cutting/welding prolly needed).PENDING
same story with the downpipe. I could only fit a 2.25" becasue 1st gens have no room. im sure the downpipe will fit other cars but its a bit small- 45shipped
$2500 for everything
$2400 without the intercooler piping
$2350 without the downpipe
Modified by .m a c a at 5:12 PM 7/17/2006
ALL ITEMS have less than 1k miles on thme and were purchased BRAND NEW
I WILL Part the kit out!!!!!!!!!!
-Garrett GT32 .50 cold/.78 hot W/custom internal wastegate at 8psi (purchased brand new was $750. $630shipped includes special oil feed flange and CUSTOM MADE 7.5psi internal wastegate (original wastegate was 22psi)
90 silicon elbow off turbo ($40 new) $25shipped or +$20 if u buy it with the turbo
-LSD motorsports log mani - $200shipped
-Precision 440 injectors (no resistor box needed!) 200shipped
-HKS "style" ssqv BOV- PENDING
- Joe P. Manual Boost controller "new style"- 35 shipped
-Stealthmode oil line kit, all necessary fittings/clamp/bolts (block fitting, feed line, turbo fittings, return line, oil pan flange NOT included)- PENDING
-tapped and welded oil pan- PENDING
-Johnny race car 6" intercool with extra mounting tabs- $170 shipped extra mounting tabs included
-Defi D-Gauge Boost gauge (lights up red, has been discontinued, hard to find)- PENDING
plenty of 2.5" high quality silicon couplers and tbolt clamps- make offer
-vacuum lines and t-fittings
- i will include 3 OBDI chips with crome pro tuned by xenocron for this setup. this should not be long term but it should run your car quite well until you can get your own tune- make offer
I will include the 2.5" mandrel bent intercooler piping which is for a 1st gen crx. they MAY fit a 2g but i doubt it will be direct (some cutting/welding prolly needed).PENDING
same story with the downpipe. I could only fit a 2.25" becasue 1st gens have no room. im sure the downpipe will fit other cars but its a bit small- 45shipped
$2500 for everything
$2400 without the intercooler piping
$2350 without the downpipe
Modified by .m a c a at 5:12 PM 7/17/2006
Trending Topics
Thread Starter
Honda-Tech Member
Joined: Jan 2003
Posts: 7,987
Likes: 4
From: UPSTATE 518
Re: Bseries Turbo Kit, very slightly used, $2500- New York (Mike M)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mike M »</TD></TR><TR><TD CLASS="quote">I wear pants</TD></TR></TABLE>
damn i couldve sworn that was a skirt
damn i couldve sworn that was a skirt
Thread Starter
Honda-Tech Member
Joined: Jan 2003
Posts: 7,987
Likes: 4
From: UPSTATE 518
Re: Bseries Turbo Kit, very slightly used, $2500- New York (crawdad689)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by crawdad689 »</TD></TR><TR><TD CLASS="quote">I can vouch for ryan and the quality/condition of this kit. **** is A+++++.
</TD></TR></TABLE>
thanks . c r a w
</TD></TR></TABLE>
thanks . c r a w
Thread Starter
Honda-Tech Member
Joined: Jan 2003
Posts: 7,987
Likes: 4
From: UPSTATE 518
Re: (gots_a_sol)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by gots_a_sol »</TD></TR><TR><TD CLASS="quote">send me some pixors of the mounting tabs on the ic son</TD></TR></TABLE>
Will do, some of them are brand new, the used ones need to be painted
bump it up
Will do, some of them are brand new, the used ones need to be painted
bump it up
Thread
Thread Starter
Forum
Replies
Last Post
papasmurf03
Classifieds: Forced Induction
4
Feb 22, 2012 05:54 PM
1990hf
Classifieds: Forced Induction
11
Mar 7, 2009 07:35 PM
Hoffy
Classifieds: Forced Induction
13
Jul 28, 2005 05:43 PM