i'm putting a sohc zc out of a 90 crx si into my 90 dx hatch. is there an easier way of doing the wiring than actuallt removing the dx and si wiring harness (from under the hood and dash) and swaping them aroung? i'm talking fuese boxes all the under dash wiring everything. dose all this need to be swaped in order to run my multi port motor on my duelport car? or will it just be easier.

 

yeah you wire i the cyl postion sensor and the new injecotors and inj resistor box to the dx harness.

 

do i need to tie them in with other wires or do i just run them straight to the ecu. wiring is not my stong point, likely my weakest