Need a replacement motor. Prefer full motor, but will consider block only. Prefered in Cincinnati/tri state area.

 

Need a motor bump

 

up

 

i'm in cincy, and i have a Y8 block and head. head needs hot-tanked, block needs bearings replaced and is missing 2 rods and 2 pistons. looking for $150 OBO for all. PM me if interested.

 

I will keep you in mind. Would be easier for me if i can find a complete motor. The one in the car now has a spun bearing. I bought this car just to fix and sell. May be interested in your rims as well.

 

ttt

 

I've got a d16z6 fur cheap!

 

getting warmer.

 

pm sent

 

Thanks for the offer b16civict, but i think shipping from washington would not be worth it. If you would like to check on it my zip is 41075.

 

i have a complete d16y8 pm me

 

pm'd

 

Complete Y8 shortblock 120,000 miles $150 bucks

 

That would be great if you were local.

 

i got a d16y8 block, with all pistons, rods, bearings, crank, oil pan, basically the whole short block. just needs a hone job. 68,000 miles on it. heres a pic if you would like.

located in baltimore MD, but will be happy to ship out.

 

Thanks for the offer, but i dont think it would be worth it after shipping.

Looking for something Local.

 

bump

 

well, shoot a fair offer, im in MD, and your in KY, not too far, im very reasonable.

 

Thanks for the offer. The motor in this car now runs, it just started knocking. Im sure it is a spun bearing. I think it might be easier to fix the one it it now than hone the one you have for sale. I am just trying to find a motor that is ready to swap in, or just throw a head on it and swap in. If i do not find one local in the next week or 2 I will have the motor out and may just repair it as long as it is feasible. This car is not my daily driver, so i am in no hurry. I bought it just to fix and prolly sell. 97 EX 4 door with 109,XXX for $500. Dudes GF ran it low/out of oil. It runs but is knocking. So i am really trying to find something with in driving distance and cheap. I will keep you in mind though.

 

well, the engine came out of a running car like almost 2 weeks ago. the guy did a b16 swap. the motor really does not need a hone, but its always proper engine building techniques here. the thing has 68,xxx miles on it out of a 2000 ex. only ran with mild bolt ons like intake, header. it should be perfectly fine to put in right away. and, im only looking for like 275-300 shipped.

 

ttt

 

just put new rod bearings in it, jeez.. dont drive it either and you might be able to get away without getting a new crank, very easy just take the oil pan off...