Here are a couple of pics i took last night. I just installed the fenders too. http://doogy_2.tripod.com/Chris.html


[Modified by ZC_CRX, 7:25 PM 3/6/2002]

 

Your going to add a lot more to your list of mods right?

For turbo + Nitrous = lots of tunning, money, and work.

You can see pics of my ZC turbo under my SIG...


[Modified by Bryson, 5:00 PM 3/6/2002]


[Modified by Bryson, 5:00 PM 3/6/2002]

 

Where did you run your oil lines from on the turbo? I was goining to use the pulg above the oil filter.

 

Car looks ok

 

I thought those were Z3 fenders, not ZC fenders. I think a ZC hood would've been money better spent so that you have that little extra bit of room under there. The valve cover looks good though. Mine will either be aluminum or polished with a couple clear coats.

 

How good do those z3 fenders fit, i just bought them for my crx last week

 

I tee'd off the oil pressure sensor(the one above the oil filter) using adapters for metric brake lines.

 

The passanger side needed to be adjusted a little bit (I drilled the bolt holes slightly larger) also the you will have to use 3m double stick tape to hold on your lower molding peices because the holes in the Z3 fenders are not the same as the stock ones, or you can use plastic push tabs to hold on the metal clip. Other than that the install was smooth.