I just replaced the act street clutch with an act 6 puck Xtreme. This is the first time building a front wheel drive car. I can't seem to get the axles to fit back in the trans. Does anyone have a solution for me?

 

well don't force it to much (as in hit it hard ) just try to find the gear by truning the axle whene it feels that it locked up push it in by pulling and pushing the axle or hit it in slowly with a ruber hammer

 

it requires a nice little push to get the clip to snap in, dont be afraid to muscle it a little-

 

yea you have to push!
it will make a nice CLICK when it goes in.

 

To test whether it is your snap ring or not, try putting it in without the snap ring. If that's the problem then tighten up the set ring.