DC Header O-ring question...
Thread Starter
Honda-Tech Member
Joined: Jan 2002
Posts: 11,669
Likes: 0
From: NY, USA
DC Header O-ring question...
Okay I just got my 2-piece DC header in the mail today. The o-rings that came with them are flat on one side. Does the flat side face the lower or upper part of the header, or does it even matter??
[Modified by ebelp, 9:25 PM 2/26/2002]
[Modified by ebelp, 9:25 PM 2/26/2002]
Joined: Jan 2002
Posts: 207
Likes: 0
From: 1 of the few non arrogant, ITR owners, USA
Re: DC Header O-ring question... (ebelp)
The flat side should butt up gainst the new header, and the tapered edge to the cat. Are we talking about the same one here?
[Modified by itr0045, 10:08 PM 2/26/2002]
[Modified by itr0045, 10:08 PM 2/26/2002]
Honda-Tech Member
Joined: Mar 2001
Posts: 946
Likes: 0
From: San Jose, CA
Re: DC Header O-ring question... (ebelp)
your talking about the two rings that go inside the primaries correct?
if so then the other part is the donut gaskt that connects the header to the cat, but the two o rings should have the flat side up, meaning touching the other part of the two piece header that is attatched to your block
if so then the other part is the donut gaskt that connects the header to the cat, but the two o rings should have the flat side up, meaning touching the other part of the two piece header that is attatched to your block
Thread
Thread Starter
Forum
Replies
Last Post
