Here is my general setup
b18c1 with pr3 pistons
OEM 2-layer head gasket
Head is milled .030
Blox Stage 2 camshafts
Skunk2 cam gears

My question is, what should i set my cam gears at before heading to tune?

I remember reading something about the milled head and thin headgasket retarding the timing.

And also, whats my compression? thx

 

Degree them in to like 106LSA intake and 108LSA exhasut to start. You can move the LSA a little tigher on the intake cam if you want to 104-100. THere is no magic cam gear setting. You need to buy a degree wheel set them to the manufacturers settings. Then make changes on the dyno to see how your motor reacts.