i need a shop in NJ to do spirolocking on my ctr pistons to fit my aftermarket rods...
or is there any other way to make this setup work without doing this? since the pin fits snug into my scat h beams.. would anyone know the price range of this to be done?

thanks alot

 

You can also have teflon buttons made.Its old school but it does work.
Glenn

 

can you explain how that works?

 

bump

 

http://www.ariaspistons.com/hardware.html
These are buttons that fit between the end of the pin and the cylinder wall.Tom Jung from arias piston is on this board (TOM J ).
Glenn