Im planning to buy either the buddy club or omni power head package which is the valves, valve spring n titanium retainers..which one should I go with? also im going with either the buddy club 5 or the skunk pro 2...my motor will be atleast 12.1 compression...this will be my daily driver but hopefully not too much.... which would you guys think would be best....buddy club or omni power head package and with which cam? yea the motor will be built all the way with sleeves and etc..its a GSR block with 84mm sleeves being done at the moment so far...thanks

 

also if anybody had bad experiences with either of these 2 valves,valve springs, and retainers or the cams let me know please before I go out and buy. thanks

 

anybody used any of these valvetrain? need some personal experiences....also how about supertech valvetrain? anyone?

 

I use full omnipower valvetrain on my ls/v (dual valve springs, ti retainers, flat faced valves) with about 20 dyno pulls and 5k of daily driving on them. many trips to around 8200 rpm with buddy club spec 3's, no problems at all.