AEM V2 Intake GSR moded to fit JRSC B18
Thread Starter
Honda-Tech Member
Joined: May 2001
Posts: 3,572
Likes: 0
From: Lynchvegas, Va, USA
AEM V2 Intake GSR moded to fit JRSC B18
Larger GSR AEM V2 with the end cut down to fit a supercharger B18 in an EG.
Because of the tight fit, engine mount rubbed a pretty good gouge as seen in picture.
It was wrapped with some racing tape (glorified duct tape) and it sealed fine.
Filter is pretty dirty, but can be inlcuded if requested.
Special tranny brace included along with all original docs and misc hardware.
100$ shipped
Modified by mrlegoman at 3:31 PM 8/7/2005
Modified by mrlegoman at 4:12 PM 1/6/2006
Because of the tight fit, engine mount rubbed a pretty good gouge as seen in picture.
It was wrapped with some racing tape (glorified duct tape) and it sealed fine.
Filter is pretty dirty, but can be inlcuded if requested.
Special tranny brace included along with all original docs and misc hardware.
100$ shipped
Modified by mrlegoman at 3:31 PM 8/7/2005
Modified by mrlegoman at 4:12 PM 1/6/2006
Thread
Thread Starter
Forum
Replies
Last Post
