Alright, I am in the process of building a B16 for my CRX

so far I have the bottom end done,
B16 block bored .20 over
Wiseco 10.75CR pistons
Eagle rods
all new bearings

The head is a 99 Si head that has been
- Ported and Polished
- 3 angle valve job
- .005" shave off the head
- new Valve seals
- Stainless Flat top valves
- Dual Valve Springs
- Titanium retainors.

I figure this setup should have a CR of about 11:1

Now what cam would be beast of this... I was thinking Skunk 2 stage 2 but I was told I might be overcamming.

this WILL be seing a 100 shot of Direct Port Nitrous as well.

any thoughts ?