I just bought a 94 gsr with 195,000 miles. The tranny was fine when i test drove it and was good til i got it home. now the car wont go into any gear at all, so i put a act clutch anda fidanza flywheel in the car, a new slave, clutch master cylinder, and a fluid change with 10w40. same problem will not go into gear while the car is running. the clutch i took out had a spring that fell out of it and i figured that was the problem, but no. if the car is off it goes in to gear fine. no noise's are coming from tranny. I already seached the topic and dident get a good explaination.
would like a little help plz. Thanks.


Modified by Doc Nasty at 9:22 PM 5/17/2005


Modified by Doc Nasty at 9:24 PM 5/17/2005

 

bump

 

little help plz.

 

are you sure you put the clutch disc in correctly?

 

for the most part i had the springs and the raised hub facing out into the pressure plate. i just started to take the tranny back out. i am starting to think you cant use a stock thorw out bearing on a act clutch.

 

you should have def. replaced your throw out bearing... you didnt use the same one that was in there did you?

 

no i bought a new koyo bearing and pilot bearing that is why i am stumped

 

yeah that shouldnt be the problem then... are you sure the shift linkage and everything else is installed properly

 

def sounds like something wasn't installed properly

 

yeah sumthin doesnt seem right
i had that same prob just after i bought my 94 gsr. it had the stock clutch and that
thing just fell apart and couldnt get it into any gear. once replaced it was fine


but u never know, could be a bent fork
what were u doin when it happened??

 

ok i just pulled the tranny again and nothing is out of whack. the only thing i can think of is that you can not use a stock replacement throw-out bearing with a act clutch set up. the bearing is for sure contacting the pressure plate but i dont think its enough. anyone know if that is the case? let me know plz.

 

check the part numbers

I have heard of ppl getting the wrong parts...from ACT

 

yeah i had the wrong throw bearing for the integra.