i just have a question to you guys that run boost out there.what do i need to do to my bottom end so that it can hold up to 18 psi without the motor blowing up.what are the best brands out there for a h22a motor and how much would i have to spend to get the setup i want

 

psi means nothing, Hp does and if you want alot and it sounds like you do. You will need to resleeve it and buy some forged internals

 

I agree with Benjithx.....just get the block sleeved, get rods/pistons (forged), and get it TUNED most of all.

 

how much would it cost to resleeve it and who does that kind of work in the tampa bay area

 

i would reccomend sending out the block to the company that produces the sleeves... like benson, golden eagle, darton, aebs, etc... I have found that the actualy manufacturer of the product does the best install since they have the most hands on knowledge of their product

 

got my eagle/8.8:1 wiseco's for $794 from race engineering in Florida http://www.raceeng.com/ Them came to Ohio in like 2 days.

Sleeves typically cost about $1000 for the parts plus labor and what not.

 

wtf lol what is so special about 18psi?