Where in the world does the Hasport Sub-Harness for B16 in CRX HF (89) Go?! HOW AND WHERE DOES IT GO?! i need pictures or some intructions....im confused.....i have everything ready and this is the only hold up....the wiring

Car:1989 Honda CRX HF
Engine:B16 JDM & OBD0

Just in case this info works......

 

The harness runs from the extra sensors (VTEC Solenoid, VTEC Oil Pressure, Knock Sensor, 2nd O2) to the ecu at the correct pin locations. It's pretty straightforward..

They come with instructions when you order them for easy installation.

 

basically you just hvae to get the wires threw the firewall....not really an exact place just get it threw near the fuel filter....down about a foot there is a gromet there you can push out

 

ok, so i install the HF harness on the motor and then hook it up right? Then i connect the harness to the V-tec sensors? Then to the ecu? That seems like a no brainer......correct me if im wrong

 

You've pretty much got it, install the HF harness onto the b16, and then the hasport subharness, drop the motor in, run the hasport subharness through the firewall and plug the pins in at the correct locations at the ecu plugs, and you're done..

 

alright cool i got the sub harness figured out.....But about the HF harness....it plugs up to the engine pretty much the same right? I wont need to extend wires?