Well tryed to take my gauges out today to replace 1 of the burnt out bulbs. Well i got the 3 screws out, and can get the right side out, but the edge of left side (door) just wont come out. Am i missing a screw or something or am i just not pulling on it hard enough, been hesitenet to abuse it.

 

what car?

 

my bad, sedan civic honda 94

 

https://honda-tech.com/zerothread?id=661308

That will tell you how to take the whole cluster out.

 

ya, thats where i got the motovation to start this "project" from. So i guess i will just go to town on it. Thanks for the time

 

there are metal clips that hold it itn just make sure u got all the screws out that it lists 2 on top of gauge cluster and one behind the hazzards. and then pull it carefully and take your time and u will get it out.

 

busted (:, cracked just above the vents, but should hide well, I HOPE when i glue it back together

 

hmm thats crapy man how were u pullin on it, i have pulled mine out like 10 times and not broken it once.

 

yeah me too.
i never broke mine, i am tryin to think how it could break

 

on mine, there is only 2 screws holding the cluster in.

and i think 3 holding the trim in, well not any more, it just sits there, in place by the metal bracket things

 

wasnt being very patient (SP) and was pulling on it and i missed 1 of the clips, and of course, crap, pop, busted. but oh well, crap happens. Glued it back up, and came out pritty good.