We have everything wired up in my Rex. We are using a B16 Ecu and have ran everything. Vtec is wired to pin A8. I am still throwing a 21 (vtec solenoid). We tested the solenoid and it is still good. Also I am throwing a Crank Position (4). We have tried 2 dizzies and I know 1 of them is good because it came out of my car to do the GSR swap... And I am using a Skunk2 manifold.... HELP!!

 

your getting the vtec code because the pressure isnt grounded to the chassis i believe.

Even though it should still start. CHeck your grounds.

 

Yes it is grounded to the car. And the car starts and runs fine it just doesn t hit Vtec. Of course I didn t take the car up past 5000 rpm's.

 

knowledge bump