I am just wondering how I will connect this to the charge piping? I know some people had to run into this same problem with their t3 .48/.60's. Did you use a flange or somehow just fit a silicon connector with a clamp over the flange? Thanks a lot.

 

get the right flange, than weld a peace of pipe of the same size to it and run it out about 2" than just get a silocone connector on with your intercooler pipe and your good to go.

 

thanks, thats pretty much what i was thinking... anyone know where to find this flange?

 

http://www.atpturbo.com/Mercha...e=FLA

this one is for the inlet I beleive

check that out?

 

they're the same basic shape but the one on the turbo is a bit smaller

 

did that turbo come off of a car? or is it just some turbonetics turbo?

 

I'm pretty sure its off an automatic T-bird