Whats up guys,
I have the option to buy an auto d16y7 motor for my turbo build up. I was considering using the d16y7 block, and taking the d16z6 head off of my current motor and putting it on the y7 block.

I'm no newb to all of this stuff, but I'm curious is there any wiring issues on the d16y7 where it is OBDII?

Here is a pic to get people to actually look in here. Your welcome.

 

I guess I should have said.

I'm planning on using LS Rods and Vitara pistons. Perhaps posting the block, but I'm unsure of that yet. Hoping for 8psi daily and 14-15 at the track out of the DSM t25.

 

nope. you'll be fine, just swap over the sensors from the y7 head to the z6 head. You can skip the IAT though, because gauging by your sig, this is going into an obd1 car