What's a good tool to use to install my new Brian crower dual valve Springs into my b series vtec head. For oem springs I use the zip ties method but these are to stiff

 

Anyone?

 

 

I've seen those on ebay was skeptical about them but I guess other people do use them.

 

https://www.amazon.ca/SUPERCRAZY-Eng...ve+spring+tool This is what I have, works great. 94

 

Got a picture of it installed?

 

they make a valve spring installer. the one i ordered worked but it was too hard to press down on because they were dual brian crower springs. i just used a big bar clamp and put it to where i could use the clamp and press down on the intsaller. worked like a charm lol that euro port tool looks like it would work a lot better.

 

I switched to the euro export tool because you don't need to hold it while fishing the keepers in or out. It's especially helpful if the springs have a lot of seat pressure. I previously had the universal snap-on compressor tool.