On the website it shows B18c Vtec but not sure if they are long enough for a gsr bottom end ?

http://www.eaglerod.com/index.php?op...d=21&Itemid=32

Part Number 5394.BHO










.

 

NOTES:
standard rod for B18A, B18B, B20B, B20Z. Older design used 5/16" bolt (3/8" head) - torque was 28 ftlbs with moly lube.


This was in the bottom of the page in the *notes* section. This means that the rods you are looking at are for the NON-VTEC B series engines listed. They can be used in a B18c IF you're running an LS crank. GSR crank requires the proper Eagle rods for that application.

 

Figured, just to make sure. Thanks