Need help with poor mans r setup!!
Thread Starter
Honda-Tech Member
Joined: Dec 2004
Posts: 231
Likes: 0
From: bailtimore, md, bailtimore
Need help with poor mans r setup!!
Basically I have full rev valvetrain with stage 2 skunk2 cams going onto gsr block
but i am trying to figure out the best way to gain the compression back from putting that head on the car either thinner head gasket or mill the head. If i was to mill the head how would i calculate how much to mill??
any help appreciated
but i am trying to figure out the best way to gain the compression back from putting that head on the car either thinner head gasket or mill the head. If i was to mill the head how would i calculate how much to mill??
any help appreciated
Thread
Thread Starter
Forum
Replies
Last Post
blowme
All Motor / Naturally Aspirated
10
Jul 9, 2005 12:28 AM