There is a dedicated K Motor Forum that is a subforum of the All Motor Forum:

https://honda-tech.com/forums/k-series-153/

 

awsome

 

Thank You.

 

Hi, I'm located in the Texas Austin area and I wanted to ask if anyone has any recommendations for a good Dyno Tuning Shop for K24a2. Thanks for any feed back.

 

I have an em2 with a k20a3 swap but I recently spun a road bearing. A buddy of mine recently replaced all of his stock internals in his z3 (valves, cams,rockers, positions, rods,crank, I mean everything. I was wondering, one would these parts fit in my 20a3, if so would this make it true vtec and what benefits would I see

 

Your posting in the wrong section. The link with information you need is in the original post.

 

I'm currently doing a k24a motor and a k24z7 tranny on my ek what halfshaft,axles and clutch should I use thanks

 

I am not sure why you would use the K24Z7 trans... but I will bite.
Use base RSX axles and half-shaft and a clutch and flywheel from a RSX-S (K20A2).

 

I have a k24a and I bought a ktuned ep3 pulle and it won't line up with alternator or nothing else any idea?

 

Wrong water pump housing.

 

which one do I need?