help with cam timing on mini me
#1
Honda-Tech Member
Thread Starter
Join Date: Oct 2004
Location: usa
Posts: 913
Likes: 0
Received 0 Likes
on
0 Posts
help with cam timing on mini me
hey guys i got a d15b7 block and a z6 head wiht a y8 cam gear i dont know why but i just replaced myhead gasket so i could take out that little oil stopper thing in the block. but now my car willl not start souded like the spark plug wires were off but they wernt and so i am not sure if i have my cam timing set right. i do not have the covers i got one on my old motor but when i put this block at tdc by putting a long extention in cylnder one and turn it tell it goes all the way up the mark on the crank is way off from my where the mark on my other cover is its like down..... but this said...once i get cylnder one tdc how do i knwo where the marks on my cam are for my head to be at tdc??? i thought it was right when the first intake valve was about to open..... any hlep will help thanks!!!!!! i need my car running by tomorrow.... sorry about this confusing peragraph i am not too good with typing and explaining
#2
Honda-Tech Member
Thread Starter
Join Date: Oct 2004
Location: usa
Posts: 913
Likes: 0
Received 0 Likes
on
0 Posts
Re: help with cam timing on mini me
hey sorry i am a dumb ***. i just saw the up on the gear it was barly there but now i got it there. i have 180 compression in all cylnders but in four its only 80??????? and when i crank the car it almost starts but dose not and my plugs get all soked in fuel.... should it still start with that little compression in the last cylnder or could this be why its not starting?
Thread
Thread Starter
Forum
Replies
Last Post
blacktibby07
Honda Civic / Del Sol (1992 - 2000)
3
05-08-2011 09:46 AM
O16581724 5 2 5
Honda CRX / EF Civic (1988 - 1991)
2
07-05-2006 07:29 AM