help
#1
Thread Starter
Join Date: Aug 2002
Location: Boca Raton, fl, us
Posts: 294
Likes: 0
Received 0 Likes
on
0 Posts
help
just finished installing jkobd.com ecu adapter, dist adapter and ecu using a jdm unchipped p28 replaceing my obd0 chipped pr3
i wired the vtec oil presure sensor and vtec wire but left the 4 wire o2 and the knock sensor un-wire being as though i am going to tune them out very soon using Neptune at titan motorsports in orlando
start up went great experienced a somewhat high idle but my idle was slightly high before with my engine set up ... let the engine warm up and then free revved to check vtec engagement and it his a fuel cut like rev limiter at about 4500 or so rpms ... anyone have any input? think it is because of the cel for no o2 and knock sensor?
i wired the vtec oil presure sensor and vtec wire but left the 4 wire o2 and the knock sensor un-wire being as though i am going to tune them out very soon using Neptune at titan motorsports in orlando
start up went great experienced a somewhat high idle but my idle was slightly high before with my engine set up ... let the engine warm up and then free revved to check vtec engagement and it his a fuel cut like rev limiter at about 4500 or so rpms ... anyone have any input? think it is because of the cel for no o2 and knock sensor?
Thread
Thread Starter
Forum
Replies
Last Post