ok, I took out my ecu today to see what chip it had in it, I put it back in and now I have no vtec, but, I do have 2 loose wires that are stripped and may have been in the ecu plug. I need to know where they go. The ECU is a 92 h23 ecu. I need to run the wires for vtec again since I think I accidentally pulled them out... Any idea where to plug them in? I found 2 slots where the pins are missing and they look kinda gouged a little... so I think that is where these wires go, but not sure what order... can anyone help me???
The ECU is a JUN P13 (written on the cover...)


Modified by 92vteclude at 2:45 PM 11/19/2005

 

If that is a REAL Jun ECU then that's a nice little piece... But uh.. How is it "The ECU is a 92 h23 ecu"? H23 = No VTec, so H23 ECU = No VTec. But it's "The ECU is a JUN P13" also..

So confused.... :S

 

yea forgot to edit that. The harness is still a H23... not the ecu... It says JUN P13 on the side, how do I tell if it is real? Can it be tuned? any idea how to wire vtec? The articles I have seen say A4 and D6, this doesnt make sense.... is it on the top of the plug?? or the bottom?

 

Nope, no idea.. I have completely forgot at the moment.. And I will be having to do that soon.. Dang.. If I remember or find my info I'll let ya know.. Sorry

 

check the faq, there is an ecu pin out, the pin out is showing the harness part.

 

Thanks Steve! I should have looked there first, the picture of the plugs helped a ton!! Thank you! Now this will be tomorrow's project...
~Joe~

 

Ok, all set, thanks guys!